Please note that there are both smaller and larger filters and UV systems which may be appropriate, depending on the circumstances.

Often other sources of water such as bore, stream, lake, springs, etc., may be used instead of or to supplement the tank water. In some of these cases the treatment may need to be varied or extended to suit particular problems. If in doubt contact us for further advice.

THE ADVANCED WAY TO PROTECT YOUR WATER
• Lamp rated life 9,000 hrs
• Seven year warranty on reactor chamber

UVA2A • UV12AS
From compact point-of-use to whole house sterilisation units

Safe, Economical, and Environment‑friendly
The brand‑new point‑of‑use and whole house UV germicidal units, Germicidalight is specifically designed for offering excellent water treatment to all domestic and small commercial applications.

The principle of Germicidalight lies in employing the 254 nm ultraviolet rays (UV‑C) to cause immediate death for organisms or wipe out thier ability to survive or reproduce. The Germicidalight supersedes sterilizing chemicals (such as chlorine and chlorine mixtures) as it does not bring about the side effects of chemicals. Furthermore, the disinfectant efficiency is several times as much as that of chlorine and chlorine mixtures. It is much safer to use and operate (no toxic chemicals to handle).

Many older type UV germicidal units used plastic components that corrode under ultraviolet rays. These of course not only broke down but also potentially cause the release of toxins and odours. Consumers may now feel at ease, since the brand‑new Germicidalight is made out of stainless steel and is convenient for consumers to wash and maintain. It is also easy to replace the UV lamp without needing to turn off the flow. There is a double check safety feature with LED visual alarm with back‑up audible alarm. The highly efficient UV lamps and quartz sleeves enhance the penetration power of ultraviolet rays and help reduce bacteria and viruses up to 99.9%.

Germicidalight manages your drinking water in an ecological way for you and the environment. It is safe, economical and environmental‑friendly!! Last but not least, it deserves your consideration.

The following picture is about the comparison of three cultured water samples tested at the American Medical Study Laboratory.

 

REPLACEMENT PARTS
MODEL NO.	DESCRIPTION
LS287T5L/4	UV lamp for 2A
LS436T5L/4	UV lamp for 6A
LS36T5L4	UV lamp for 12A
LS-001	330 mm quartz sleeves for 2A
LS-006	463 mm quartz sleeves for 6A
LS-012	890 mm quartz sleeves for 12A
OR-2335	O-ring for all quartz sleeves

WARRANTY
WaterTec® co. offers a seven‑year warranty on the stainless reactor chamber and one‑year warranty on the other components (consumable parts excluded).

• Either dirt/sediment filter for rural water (AP110, AP111, AP124)
• Or AP117/MBAC10 carbon filter for chlorine removal, taste, odour, colour
• Flow rate with AP 117 is 10 L/min.
  Flow rate with AP 110 is 25 L/min.
  Flow rate with AP 111 is 25 L/min.
  Flow rate with AP 124 is 25 L/min.
• Connections 3/4" BSP inlet/outlet
• Pressure rating 125 psi max. ‑AP11S, AP11T
• Fitted in‑line for tidy installation
• Bleed valve & bracket included

AQ101 (cartridge not included)

• Takes 9 3/4" cartridges
• Pressure rating: 125 psi
• 3/4" BSP taper connections

AP12S, AP12T double length whole house housing
For higher flow rates on whole house applications. Uses two cartridges/housing, either carbon or sediment as above.

• Connections 3/4" BSP inlet/outlet
• Flow rates up to 2 x AP11 housing above
• Pressure rating 125 psi maximum
• Ideal for whole house Giardia/Cryptosporidium with Cystguard cartridge
• Bleed valve included

High Pressure Housings
FS10
Heavy duty nylon housing for higher water pressure areas. Supplied with mounting bracket.

• Flow rates as for AP11 housings above
• Connections 3/4" BSP inlet/outlet
• Maximum pressure 200 psi.

AP1610 Housing
Stainless steel 10" housing for higher pressure applications or hot water. Fits all Aqua‑Pure cartridges ‑ AP110, AP111, AP124 and carbon/pleated cartridges.

• Connections 3/4" BSP inlet/outlet
• Flow rates as for AP11 housings above
• Maximum pressure 300 psi
• Maximum temperature 99°C
• Also available AP2610 20" housing

NOTE FOR ALL HOUSINGS!
Where pressure is known to be higher than housing rating or water hammer is present install: a) Pressure reducing valve or b) Water hammer arrester.
Use only tapered BSP fitting.

Note, exceeding flow rates & pressures voids warranty!

Heavy‑duty Filter Housings
AP801 "JUMBO"
high flow housing for whole house filtration (cartridge not included)

• 1" BSP inlet/outlet (includes bracket & spanner)
• Pressure rating 100 psi maximum
• Choices like AP817A carbon cartridge for taste/odour removal or AP810 for dirt/sediment removal

AP802 "JUMBO" 20"
high flow housing for whole house filtration (cartridge not included)

• 1" BSP inlet/outlet (includes bracket & spanner)
• Joiner required between 2 x 10" cartridges
• Takes 20" cartridges as below
• Maximum pressure rating: 100 psi

Jumbo Filter Cartridges
Pleated Cartridges
AP8001 – Dirt/Rust/Giardia

• Pleated polyester, 1 micron washable, flow rate 56 L/min.

AP8001‑2 ‑ 20" Jumbo 1 micron polyester
flow rate 113 L/min. (Dirt/Rust/Giardia)
AP805 ‑ 10" Jumbo 5 micron polyester flow rate 56 L/min. (Dirt/Rust)
AP805‑2 ‑ 20" Jumbo 5 micron polyester flow rate 113 L/min. (Dirt/Rust)
AP820 ‑ 10" Jumbo 20 micron polyester flow rate 56 L/min. (Dirt/Rust)
AP820‑2 ‑ 20" Jumbo 20 micron polyester flow rate 113 L/min. (Dirt/Rust)

Resin Bonded Depth Cartridges
For fine dirt, rust and sediment removal.
AP810 ‑ 10" Jumbo 5 micron, flow rate 75 L/min.
AP810‑2 ‑ 20" Jumbo 5 micron, flow rate 170 L/min.
AP811 ‑ 10" Jumbo 25 micron, flow rate 75 L/min.
AP811‑2 ‑ 20" Jumbo 25 micron, flow rate 170 L/min.

Blanket Media Cartridges
For fine dirt, rust and sediment removal.
AP814 ‑ 10" Jumbo 50 micron, flow rate 75 L/min.
AP814‑2 ‑ 20" Jumbo 50 micron, flow rate 170 L/min.

Carbon Media
AP817A ‑ Taste/Odour/Chlorine

• 5 micron, carbon block cartridge, flow rate 30 L/min.

Where pressure is known to be higher than housing rating or water hammer is present install: a) Pressure reducing valve or b) Water hammer arrester. Where water flow may exceed design, fit a flow restricter.

Note, exceeding flow rates & pressures voids warranty!

AP8000 Complete Under Sink Chemicals/Chlorine/Taste/0dour/Dirt/Giardia/Cryptosporidium.

• Used for municipal or rural water
• When used in rural instances, use cartridge change guide on instructions
• When used on municipal water cartridge life is approx. 12 months or more depending on water condition
• Comes with Do‑It‑Yourself‑Kit, individual "Touch Flo" faucet, and cartridge
• Flow rate 7.5 L/min, maximum pressure 125 psi
• Complete with dual check valve & pressure reducing valve
• Unique simple to change cartridge (Uses CFS811112 replacement filter cartridge).

AP900
Dirt/Rust/Taste/0dour/Chlorine/Giardia/Crypto

• Use where under bench space is at a premium
• Complete with Do‑It‑Yourself Kit including fittings and designer bench faucet
• Flow rate 3.0 L/min., maximum pressure 125 psi. (Use 41‑ILCL‑1 replacement filter cartridge)
• Complete with dual check valve & pressure reducing valve

AQ101US
Dirt/Rust/Taste/Odour/Chlorine

• Underbench kit (tap & fittings included)
• Takes 93/4" or 10" cartridge (not included)

APBT301C
New design counter top with built‑in cartridge change indicator (green ‑ "OK", red ‑ "Change Cartridge").

• For dirt, taste, odour & chlorine removal
• Includes cyst carbon filter
• Flow rate: 8 L/min, max. pressure: 100 psi
• Includes diverter & male adapter (no installation required)
• Batteries not included

AP717 Ice Maker Filter
Dirt/Taste/Odour/Chlorine/Scale Inhibitor
For coffee machines, ice makers, fridges with ice maker facility.

• Flow rate 1.9 L/min., max. pressure 125 psi
• Includes Silphos for scale protection
• Used as replacement cartridge for AP700 / AP Max A

Phone: 06 324 8426
Fax: 06 324 8427
Email: admin@farmsupplies.co.nz
Website: www.farmsupplies.co.nz
Address: 55 Thames Street Rongotea